Plastica Powerpack 100 Motor with 15m x 7 Core Wire

If the existing Power Pack is a Slidelock model, it should be compatible with the current reel system.

Yes, to accommodate the Power Pack, both the steering wheel and the end boss must be unscrewed from the reel system.

Fifteen years ago, the same extrusion was used on the tube as is currently employed. Therefore, as long as the Slidelock system is indeed 15 years old, the Power Pack should fit seamlessly. However, if the system in question is a Reel Easy Telescopic...

In these circumstances, the current Power Pack system should be compatible with the older setup. While it features a different remote and control panel, we believe it can be successfully integrated.

As long as the older motor is a 7-wire model, it should be suitable. And typically, a Power Pack 100 from 2007 would be equipped with a 7-wire system.

The standard cable for the Power Pack is 0.75mm with a 2 x 7 configuration. However, if an extension is required, the cable's size should be increased to at least 1mm² to 1.5mm², depending on the extension length. This increase in core size is necessary...

The standard warranty period for the PRD90501 - Power Pack Motor is two years.

Our recommendation would be against using the Power Pack motor for non-Plastica systems, as it requires specific sleeves to fit inside the customer's tube, which we do not supply. It would be more advisable to purchase a compatible reel as well.